MODSYSCF - CUSTOMS OFFICE CONFIGURATION Ó UNCTAD - SITE (V1.15) 9.8 Additional functions can be set ‘Yes’ or ‘No’ for either Export or Import processes. These are: ·     Selectivity ·     Selectivity post entry ·     Automatic assignment of sections ·     Automatic assignment of examiners ·     Automatic assignment of chief examiners These   functions   are   fully   explained   in   other   Sections   of   this   Manual.   See Section 6 of this Reference Document, ‘Selectivity Management’ for details on selectivity controls and automatic assignment for examinations. After  updating  the  system  you  must  log  onto  the  server  and  send  the  configuration  to  the  server using the Configuration transfer option. 'System Parameters' screen: - Fig 9.2 MODSYSCF Functions System Parameters Manifest ‘Learning Mode’ When the manifest function is used, declarations that are assessed against a Manifest will write-off the Bills Of Lading (B/L), but it can happen that many declarations are rejected. Declarations may be rejected because the Manifest has not arrived, (i.e. not ‘registered’), and is not in the database. ‘Learning mode’ allows the assessment of declarations that do not match a Manifest. If    ‘Manifest’   in   ‘MODSYSCF’,‘Functions’,‘System   parameters’    is   set   to    ‘Yes’    then    the declaration is linked a to a Manifest. The quantities or weights from the declaration write off the Bill Of Lading. When  ‘Manifest’ is set to  ‘Learning Mode’ a declaration can be assessed even if the Manifest  does  not  exist.  This  can  be  useful  in  situations  where  the  Manifest  is  not  yet  available when assessing a declaration. When   all   Manifests   are   present   in   the   database   before   assessment,   the ‘Manifest’ flag should be switched back to ‘Yes’. For more details of the Manifest function when the system parameter is set to ‘Learning mode’, see Section 5 of this Reference Document.